tag:blogger.com,1999:blog-4379675038340735292.post7802158180304608967..comments2022-04-07T18:46:39.430-07:00Comments on Somewhere in the boundary layer...: HOW TO: Up and running with Adafruit HUZZAH Feather ESP8266ImagineN4tionhttp://www.blogger.com/profile/00796429891687193684noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-4379675038340735292.post-73105947697064637712017-02-10T00:38:45.689-08:002017-02-10T00:38:45.689-08:00thanks for the write up helped me outthanks for the write up helped me outjarrodlhttps://www.blogger.com/profile/11844805349800445672noreply@blogger.comtag:blogger.com,1999:blog-4379675038340735292.post-3399076359993906712015-12-20T12:31:02.714-08:002015-12-20T12:31:02.714-08:00Thanks for sharing this troubleshooting tip George...Thanks for sharing this troubleshooting tip George! I added this information to the post as well in hopes that it may help others.ImagineN4tionhttps://www.blogger.com/profile/00796429891687193684noreply@blogger.comtag:blogger.com,1999:blog-4379675038340735292.post-76840204997928195642015-12-15T11:10:08.399-08:002015-12-15T11:10:08.399-08:00I found it was necessary to connect GPIO pin 0 to ...I found it was necessary to connect GPIO pin 0 to ground to get it to program reliably. Without connecting it to ground, I would often get errors during downloading.Anonymoushttps://www.blogger.com/profile/01346858802587167886noreply@blogger.com